Netgear WAG102 WAG102 Reference Manual - Page 87
Troubleshooting, No lights are lit on the wireless access point. - power supply
UPC - 606449028799
View all Netgear WAG102 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Chapter 5 Troubleshooting This chapter provides information about troubleshooting your ProSafe 802.11a/g Dual Band Wireless Access Point WAG102. After each problem description, instructions are given to help you diagnose and solve the problem. For the common problems listed, go to the section indicated. • Is the WAG102 on? Go to "Installing the WAG102 Wireless Access Point" on page 2-4 • Have I connected the wireless access point correctly? Go to "Installing the WAG102 Wireless Access Point" on page 2-4. • I cannot remember the wireless access point's configuration password. Go to "Changing the Administrator Password" on page 3-12. Note: For up-to-date WAG102 installation details and troubleshooting guidance visit http://kbserver.netgear.com/products/WG302.asp. If you have trouble setting up your WAG102, check the tips below. No lights are lit on the wireless access point. It takes a few seconds for the power indicator to light up. Wait a minute and check the power light status on the access point. If the access point has no power. • Make sure the power cord is connected to the access point. • Make sure the power adapter is connected to a functioning power outlet. If it is in a power strip, make sure the power strip is turned on. If it is plugged directly into the wall, verify that it is not a switched outlet. • Make sure you are using the correct NETGEAR power adapter supplied with your access point. 5-1 v2.0, September 2006