Nikon 25515 User Manual - Page 151

Cleaning, Lens /Electronic Viewfinder, Monitor, Do not use alcohol, thinner

Get Nikon 25515 PDF manuals and user guides View all Nikon 25515 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 151 highlights

Technical Notes Cleaning Lens/Electronic Viewfinder One key to preserving the condition of these glass parts is to not touch them with your fingers. Remove dust or lint with a blower (typically a small device with a rubber bulb attached to one end that is pumped to produce a stream of air out the other). To remove fingerprints or other stains that can not be removed with a blower, wipe the lens or viewfinder with a soft cloth, using a spiral motion that starts in the center of the lens and works out to the edges. Monitor Remove dust or lint with a blower. To remove fingerprints and other stains, clean the monitor with a soft, dry cloth, being careful not to apply pressure. Avoid contact with liquid crystal Should the monitor or electronic viewfinder break, care should be taken to avoid injury due to broken glass and to prevent the liquid crystal from the monitor touching the skin or entering the eyes or mouth. Body Use a blower to remove dust and lint, then wipe gently with a soft, dry cloth. After using the camera at the beach or seaside, wipe off any sand or salt with a cloth lightly dampened with fresh water, then dry thoroughly. Do not use alcohol, thinner, or other volatile chemicals. Notes on the Monitor and Electronic Viewfinder • The monitor and electronic viewfinder may contain a few pixels that are always lit or that do not light. This is a characteristic common to all TFT LCD displays, and does not indicate a malfunction. Images recorded using the product will not be affected. • When you frame bright subjects, vertical comet-like streaks that whiten toward either end may appear in the monitor. This phenomenon, known as "smear," does not appear in the final photograph and does not indicate a malfunction. Some smear may appear in movies. • Images in the monitor may be difficult to see in a bright light. • The monitor is lit by an LED backlit. Should the monitor begin to dim or flicker, contact your Nikon service representative. 141

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
141
Technical Notes
Cleaning
Lens /Electronic Viewfinder
One key to preserving the condition of these glass parts is to not touch them
with your fingers.
Remove dust or lint with a
blower
(typically a small device
with a rubber bulb attached to one end that is pumped to produce a stream
of air out the other).
To remove fingerprints or other stains that can not be
removed with a blower, wipe the lens or viewfinder with a soft cloth, using
a spiral motion that starts in the center of the lens and works out to the
edges.
Monitor
Remove dust or lint with a blower.
To remove fingerprints and other stains,
clean the monitor with a soft, dry cloth, being careful not to apply pressure.
Avoid contact with liquid crystal
Should the monitor or electronic viewfinder break, care should be taken to
avoid injury due to broken glass and to prevent the liquid crystal from the
monitor touching the skin or entering the eyes or mouth.
Body
Use a blower to remove dust and lint, then wipe gently with a soft, dry cloth.
After using the camera at the beach or seaside, wipe off any sand or salt with
a cloth lightly dampened with fresh water, then dry thoroughly.
Do not use alcohol, thinner, or other volatile chemicals.
Notes on the Monitor and Electronic Viewfinder
• The monitor and electronic viewfinder may contain a few pixels that are always lit or
that do not light.
This is a characteristic common to all TFT LCD displays, and does
not indicate a malfunction.
Images recorded using the product will not be affected.
• When you frame bright subjects, vertical comet-like streaks that whiten toward either
end may appear in the monitor.
This phenomenon, known as “smear,” does not ap-
pear in the final photograph and does not indicate a malfunction.
Some smear may
appear in movies.
• Images in the monitor may be difficult to see in a bright light.
• The monitor is lit by an LED backlit.
Should the monitor begin to dim or flicker, con-
tact your Nikon service representative.