Olympus D150 D-150/C-1 Zoom Reference Manual (2.7MB) - Page 96
When image protection, single-frame erasure, all-frame erasure or formatting is impossible
View all Olympus D150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
96 TROUBLESHOOTING When the monitor cannot display images Cause Remedy See The camera is in the Shooting mode. Close the lens barrier and press the P. 42 monitor button so that the monitor turns on and displays an image. No image has been saved on the card The display shows message "NO PICTURE". P. 42 in use. Note that playback is possible only after images P. 93 are shot. The digital camera is connected to a The monitor turns off while the camera is P. 73 TV. connected to a PC. There is a problem with the card. Check the error message. P. 93 When image protection, single-frame erasure, all-frame erasure or formatting is impossible Cause Remedy See A write protect seal is attached to the Remove the seal. Note that the removed seal P. 25 card. should not be reused. When an error message is displayed during data downloading to the connected PC Cause Remedy See The cable is not connected properly. Check that it is connected properly. P. 84 The camera is off. Press the monitor button to turn the P. 30 camera on. The battery power is low. It is recommended to use the AC adapter P. 72 (optional) when the digital camera is connected to a PC. The USB driver is installed incorrectly Observe instructions given in the installation - in your PC. manual of the USB driver and make sure that the camera is recognized by your PC.