Onkyo TX SR800 Owner Manual - Page 18
source is set for digital input at the COAX 3 jack.
UPC - 751398004926
View all Onkyo TX SR800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Connecting to Audio/Video equipment Digital audio input (optical) Digital audio output (coaxial) S Video input Video input : Signal flow Analog audio input R (red) L (white) 7. DVD recorder, other digital video recording device (VIDEO 2) R (red) Analog audio output Video output L (white) S Video output Y PB Component video output PR DIGITAL INPUT COAX 1 PRE TRENNA FRONT SUB 2 AM AUDIO R L VIDEO S VIDEO MONITOR OUT OUT ZONE 2 3 OPT 1 2 3 DIGITAL OUTPUT OPT SURR SURR BACK / R ZONE 2 FM 75 FRONT R UDIO L SUB PHONO SURR R SURR BACK CD OUT TAPE GND IN L UDIO IN DVD OUT IN VIDEO 1 OUT IN VIDEO 2 IN VIDEO 3 R L AUDIO IN VIDEO 4 VIDEO S VIDEO COMPONENT VIDEO OUTPUT Y PB PR INPUT 1 Y PB PR INPUT 2 Y PB PR 7. Connecting a DVD recorder or other digital video recording device (VIDEO 2) Using RCA video cables, connect the video output jack (composite) of the device to the VIDEO 2 VIDEO IN jack of the TX-SR800 and connect the video input jack of the device to the VIDEO 2 VIDEO OUT jack of the TX-SR800. Or if the device has S video input and output jacks, connect them to the VIDEO 2 S VIDEO IN and OUT jacks of the TX-SR800 using S video cables. Or if the device has component video outputs, connect them to one of the banks of COMPONENT VIDEO INPUT jacks on the TX-SR800. With the initial settings of the TX-SR800, the VIDEO 2 input source is set for the COMPONENT VIDEO INPUT 2 jacks. If you connect the device to the COMPONENT VIDEO INPUT 1 jacks, this must be changed at Setup Menu → Input Setup → Video Setup → Component Video (see page 48). Using RCA audio cables, connect the audio output jacks of the device to the VIDEO 2 AUDIO IN jacks of the TX-SR800 and connect the audio input jacks of the device to the VIDEO 2 AUDIO OUT jacks of the TX-SR800. Make sure that you properly connect the left channels to the L jacks and the right channels to the R jacks. If the device has a digital output, connect it to either the DIGITAL INPUT COAX jack or DIGITAL INPUT OPT jack of the TXSR800 depending on the type of connector on the device. With the initial settings of the TX-SR800, the VIDEO 2 input source is set for digital input at the COAX 3 jack. If the digital connection is made at a different jack, this must be changed at Setup Menu → Input Setup → Digital Setup (see page 46). If the device has a digital input, connect it to the DIGITAL OUTPUT OPT jack of the TX-SR800 for digital recording of the REC OUT signal from the TX-SR800. Note: The output from the DIGITAL OUTPUT jack of the TX-SR800 is only the digital signal input to the DIGITAL INPUT jack. 18