Onkyo TX SR800 Owner Manual - Page 30

Enjoying music or videos with the TX-SR800 STANDBY/ON DISPLAY DIMMER STANDBY POWER ON OFF PURE AUDIO UPSAMPLING DIRECT/PURE AUDIO STEREO SURROUND THX DSP PHONES AUDIO SELECTOR ZONE 2 (GRN ) REC ( RED ) DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 VIDEO 5 VCR 1 VCR 2 REC OUT ZONE 2 OFF TUNI NG SETUP ENTER PRESET RE TURN MEMORY FM MODE A-FORM LISTENING MODE MEMORY CLEAR TAPE TUNER PHONO C D MASTER VOLUME VIDEO 5 INPUT DIGITAL S VIDEO VIDEO L AUDIO R TX-SR800 PHONES SLEEP MUTING Temporarily turning off the sound To turn off the sound momentarily, press the MUTING button on the remote controller. When pressed, "Muting" is displayed on the TXSR800. Press the MUTING button again to turn the sound back on. Remote controller Adjusting the bass and treble You can adjust the bass and treble levels at the Setup Menu → Audio Adjust Menu → Tone Control Sub-menu (see page 53). This function only affects the front left and right speakers, center speaker, and subwoofer. Only the bass level can be adjusted for the subwoofer (the treble adjustment is not effective). For multichannel sources, these dials will not work if the tone control is set to "Direct" or "Pure Audio." Listening with headphones To listen with headphones, plug a pair of headphones with a standard stereo plug into the PHONES jack on the TX-SR800 front panel. When you connect headphones, no sound will be heard from the speakers. When the headphones are unplugged, the TX-SR800 returns to its original listening mode. When using the headphones, you can only use the Direct, Stereo, and Mono listening modes. (Available modes can vary depending on the current input source.) If you have selected MULTI CH INPUT, you will only hear the sound only output to the front right and left channels. The headphone volume level can be adjusted at the Setup Menu (see page 60). Note: The signal to the remote zone (Zone 2) will not be affected by whether or not headphones are connected. PHONES AUDIO SELECTOR ZONE 2 (G REC ( R Using the sleep time (remote controller only) The SLEEP button enables you to set the TX-SR800 to turn off automatically after a specified time period. If you press it once, the TX-SR800 will turn off after 90 minutes. Each time it is pressed thereafter, the remaining time until the TX-SR800 turns off decreases by 10 minutes (i.e., from 90 to 80 minutes). While, the sleep function is enabled, you can press the SLEEP button to see how much time is left. If you now press the SLEEP button, the remaining time will be reduced down to the nearest 10 minutes. If it is pressed again, then the remaining time will be decreased by 10 minutes each time it is pressed (e.g., if SLEEP is pressed with the display reading 54 minutes, it will be reduced to 50 minutes. If it is pressed again, it will then be reduced to 40, then 30, and so on). If the SLEEP button is pressed when the time displayed is less than 10 minutes, the sleep function is cancelled. If you are using the remote zone (Zone 2), it will turn off at the same time as the main zone. If you want to set the sleep function for Zone 2 only, set the sleep function with main zone turned on and then put the main zone into the standby state. Remote controller 30