Onkyo TX SR800 Owner Manual - Page 7

Before using this unit Setting the voltage selector (Worldwide models only) Worldwide models are equipped with a voltage selector so that you can set your TX-SR800 to conform with local power supplies. Be sure to set this switch to match the voltage of the power supply in your area before plugging in the unit. Determine the proper voltage for your area: 220-230 V or 120 V. If the preset voltage is not correct for your area, insert a screwdriver into the groove in the switch and slide the switch all the way to the top (120 V) or bottom (220-230 V), whichever is appropriate. DIGITAL INPUT COAX 1 PRE OUT R L FRONT ANTENNA AUDIO VIDEO S VIDEO MONITOR OUT 2 3 OPT 1 SUB SURR SURR BACK / R ZONE 2 FRONT 2 R SUB 3 DIGITAL OUTPUT OPT SURR R SURR BACK GND CENTER AM OUT ZONE 2 R L L FM 75 MULTI CH INPUT L AUDIO R L CENTER PHONO CD L OUT TAPE IN R L AUDIO R L AUDIO IN DVD OUT IN VIDEO 1 OUT IN VIDEO 2 IN VIDEO 3 IN VIDEO 4 VIDEO S VIDEO COMPONENT VIDEO OUTPUT Y PB PR INPUT 1 Y PB PR INPUT 2 Y PB PR FRONT SPEAKERS R L SURR SPEAKERS R L CAUTION: SPEAKER IMPEDANCE 4 OHMS MIN. OR 6 OHMS MIN. / SPEAKER SEE INSTRUCTION MANUAL FOR CORRECT SETTINGS. VOLTAGE AC OUTLETS SWITCHED TOTAL 100W MAX. SELECTOR CENTER SPEAKER R SURR BACK/ L ZONE 2 SPEAKERS I R IN AV RECEIVER MODEL NO. TX-SR 800 REMOTE CONTROL 120V OUT VOLTAGE SELECTOR 120V 220-230V 220-230V Using the remote controller Point the remote controller toward the remote control sensor. The STANDBY indicator lights up when the unit receives a signal from the remote controller. Remote control sensor TX-SR800 STANDBY indicator 30˚ 30˚ Approx. 16 feet (5 meters) Installing the remote controller batteries 1. Remove the battery compartment cover by pressing it and sliding it in the direction shown by the arrow below. 2. Insert two AA (R6 or UM-3) batteries into the battery compartment. Carefully follow the polarity diagram (positive (+) and negative (-) symbols) inside the battery compartment. 3. After the batteries are installed and seated correctly, replace the compartment cover. 1 2 3 SEND/LEARN indicator Notes: • Make sure that the remote control sensor is not subject to strong light such as direct sunlight or inverted fluorescent light for it may prevent proper operation of the remote controller. • Using another remote controller in the same room or using the TX-SR800 near equipment that uses infrared rays may cause operational interference. • Do not put objects on the remote controller. Its buttons may be pressed by mistake and drain the batteries. • Make sure the audio rack doors do not have colored glass. Placing the TX-SR800 behind such doors may prevent proper remote controller operation. • If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate. Notes: • Do not mix new batteries with old batteries or different kinds of batteries. • To avoid corrosion, remove the batteries if the remote controller will not be used for a long time. • Remove dead batteries immediately to avoid damage from corrosion. If the remote controller does not operate smoothly, remove the old batteries and replace them both with two new AA batteries. 7