Panasonic AJSPX800P AJSPX800 User Guide - Page 19

2-9 LCD Monitor Mode indication W: Stays illuminated in 16:9 mode. DV: Stays illuminated when the recording/playback format is DV. GPS: Stays illuminated when radio waves are not received during GPS operation. GPS : Stays illuminated when radio waves are received during GPS operation. 2 P-REC: Stays illuminated when PRE RECORDING is not set to 0 seconds, and blinks when recording is continued after the recording tally lamp has gone out. NDF SLAVE HOLD W DV GPS OVER OVER 0 CTL VTCG TIME DATE P- REC 10 h Y minM MEDIA E BATT E sD frm F F LOOP DRIVE OP-SLOT 20 30 40 OO 13 -dB 24 Time code indication NDF: Stays illuminated when the time code is in non-drop frame mode. DF: Stays illuminated when the time code is in drop frame mode. SLAVE: Stays illuminated when the time code is externally locked. HOLD: Stays illuminated when the time code generator/reader value is frozen. CTL*: Stays illuminated when the DISPLAY switch is positioned at [CTL] to display the CTL count. TCG: Stays illuminated when the DISPLAY switch is positioned at [TC] (or [UB]) to display the TC (or UB) generator value. TC: Stays illuminated when the DISPLAY switch is positioned at [TC] (or [UB]) to display the TC (or UB) reader value. VTCG: Stays illuminated when the DISPLAY switch is positioned at [UB] to display the VIUB generator value. VTC: Stays illuminated when the DISPLAY switch is positioned at [UB] to display the VIUB reader value. TIME: Stays illuminated when the DISPLAY switch is positioned at [UB] to display the real-time hour, minute and second. DATE: Stays illuminated when the DISPLAY switch is positioned at [UB] to display the real-time date. No Indication: The CTL, VTGC, TIME, and DATE stay off when the DISPLAY switch is positioned at [UB] to display real time, time zone, hour and minute. Time count indication: The time code, CTL*, user bits and real time are shown. * CTL will be supported in the near future. When the DISPLAY switch is positioned at UB, each press of the HOLD button changes the indication through VTCG (VTC)  DATE  TIME  No Indication (Time Zone)  TCG (TC), in that order. LCD monitor The LCD monitor displays the video in the viewfinder. Alternatively, it can show clips on the P2 card in a thumbnail format. In thumbnail display mode, clips can be edited or deleted, or P2 cards can be formatted using the MENU BAR button and CURSOR and SET buttons. OPEN button Used to open the LCD monitor. THUMBNAIL button This button switches the content on the LCD monitor from the video in the viewfinder to clip thumbnails. Another press switches them back to the video from the viewfinder. Note that this switchover is not performed during a recording or playback. MENU BAR button In thumbnail display mode, this button allows you to manipulate the menu bar (e.g., to delete clips). CURSOR and SET buttons The four triangular buttons are the CURSOR buttons, and the center rectangular one is the SET button. They are used to select a thumbnail and manipulate the menu bar. For more information, see [Chapter 6 Manipulating Clips with Thumbnails]. 19