Panasonic AJSPX800P AJSPX800 User Guide - Page 66

5-1-2 Using an AC Power Supply When using the Panasonic AJ-B75 AC adapter 1 Plug the AJ-B75 DC OUT connector into the camera- recorder's external DC input socket. DC IN Socket 5-2 Mounting the Viewfinder and Adjusting its Position Please refer to the viewfinder instruction manual. Note: A slide rail is required to mount any viewfinder other than models AJ-VF15B or AJ-VF20WB. z If you need to buy a slide rail, please contact the store where you purchased the camera-recorder and tell them that the slide rail is a "repair part". Slide rail (VFC3995) Screws (XBS3+8VZ) Mounting the Slide Rail 1 Undo the upper two screws for AJ-VF15 or AJ-VF20W, and remove the mounting unit. Leave the screws attached to the mounting unit. AC Adapter z AJ-B75 (Optional) 2 Turn the AC adapter power ON. 3 Turn the camera-recorder power switch ON. Mounting unit Screws When using an external power supply other than the AC adapter AJ-B75, check the DC IN socket pin information to ensure correct polarity. If a +12V power supply is accidentally connected to the GND terminal, this could cause a fire or personal injury. 2 Mount the slide rail, then tighten the two screws. Slide rail 4 3 2 1 Pin No. 1 2, 3 4 Signal GND - +12V DC IN Socket z When both the battery pack and AC adapter are connected, power is supplied from the AC adapter. The battery can be removed or mounted while using the AC adapter. z When using the AC adapter, make sure you turn ON the AC adapter power before turning ON the camerarecorder's power switch. If this sequence is reversed, the camera-recorder may malfunction due to slow rising of the AC adapter output voltage. z When connecting a battery to the DC IN socket, select the battery type listed under EXT DC IN SELECT. Select EXT DC IN SELECT from the screen on the MAIN OPERATION page. In this case, however, the % display is disabled, even when using a digital battery. 66