Panasonic AJSPX800P AJSPX800 User Guide - Page 89

5. P2 Card Fully Recorded Display window indication WARNING lamp Tally lamp Viewfinder Warning tone Warning description All 7 bar indicators for remaining MEDIA capacity start blinking. Continues to light up until an operation is performed. Continues to blink 4 times per second until an operation is performed. The END indicator blinks. Continues to beep until an operation is performed. The P2 cards are recorded to maximum capacity. Recording/ playback operation The recording stops. Countermeasures Delete the clips in the P2 card or insert a new P2 card. 8. Battery Nearly Empty Display window indication One of the bars in the battery remaining indicator starts blinking. WARNING lamp Blinks once per second. Tally lamp Blinks once per second. Viewfinder The BATT LED blinks. Warning tone Beeps 4 times per second. Warning description The battery is about to run out. Recording/ playback operation Continues to operate. Countermeasures Replace the battery as required. 6. Recording Error 9. P2 Card Nearly Full Display window "00:00:00:11" appears in the time code display Display window One of the bars for remaining MEDIA capacity 7 indication field. indication starts blinking. WARNING lamp Tally lamp Viewfinder Warning tone Blinks 4 times per second while recording continues. Blinks 4 times per second while recording continues. The REC WARNING indicator lights up. Even after recording is stopped, this display continues to light up until the next operation is performed. Beeps 4 times per second while recording continues. WARNING lamp Tally lamp Viewfinder Warning tone Warning description Blinks once per second while recording continues. Blinks once per second while recording continues. The P2 card remaining capacity indicator blinks. Beeps once per second while recording continues. The total remaining capacity of all the P2 cards is two minutes or less. Warning description Recording signal processing error. Recording/ playback operation Continues to operate. Recording/ playback operation Recording stops. Countermeasures Replace the cards. If there is an empty card slot, insert a new card. Countermeasures Restart recording. Or, turn the power OFF and turn it ON again, before starting recording. 7. Low Wireless Signal Reception Display window indication WARNING lamp Tally lamp Viewfinder Warning tone Warning description No display. Blinks 4 times per second. (During pause and recording) Blinks 4 times per second while recording continues. The WIRELESS RF indicator lights up while recording continues. Beeps 4 times per second while recording continues. This error indicates poor wireless audio reception conditions. Recording/ Continues to operate without receiving the playback operation wireless microphone signal. Countermeasures Check the microphone power supply and the reception status of the wireless receiver. 7-3-2 Error Codes The following error codes are displayed in the display window if an error occurs in the camera: Code No. E-11 E-27 E-30 E-38 E-3F E-6F Description Video initialisation error Recording control error P2 card removal error P2 streaming microcontroller error Microprocessor error in the camera control circuit. Reference signal error. 89