Panasonic WV-NF284 Network Camera - Page 18

Notes: • Link indicator: This indicator will light when com- munication with the connected device is available. • Access indicator: This indicator will light when accessing to a network. • SD memory card error indicator: This indicator will light when it is impossible to write data on the SD memory card. Configure the settings relating to the NTP server [NTP] Click the [NTP] tab on the "Basic setup" page. (☞ page 15) The settings relating to the NTP server such as the NTP server address, port number, etc. can be configured on this page. Important: When entering the host name for "NTP server address", it is necessary to configure the DNS settings on the [Network] tab of the "Network setup" page. (☞ page 39) [NTP port] Enter a port number to be used for the NTP server. Available port number: 1 - 65535 Default setting: 123 [Time adjustment] Select the time adjustment method from the following. Manual setup: Time set on the [Basic] tab on the "Basic setup" page will be used as the standard time of the camera. Synchronization with NTP server: Time automatically adjusted by synchronizing with NTP server will be used as the standard time of the camera. Default setting: Manual setup [Synchronization interval] Select an interval (1 - 24 hours: in 1 hour intervals) of synchronization with the NTP server. Default setting: 1 hour [Time zone] Select a time zone according to the location where the camera is in use. Default setting: (GMT) Greenwich Mean Time: Dublin, Edinburgh, Lisbon, London [NTP server address] Enter the IP address or the host name of the NTP server. Number of characters for the NTP server address: 1 - 128 characters Default setting: (blank) 18