Panasonic WV-NF284 Network Camera - Page 33

Configure the settings relating to Panasonic alarm protocol Click the [Notification] tab on the "Alarm setup" page. (☞ page 15) ■ Panasonic alarm protocol setup The settings relating to Panasonic alarm protocol can be configured on this page. [Panasonic alarm protocol] Select "ON" or "OFF" to determine whether or not to notify of an alarm occurrence by Panasonic alarm protocol when an alarm is detected. Default setting: OFF Note: When "ON" is selected, the alarm occurrence will be notified to the registered destination IP addresses in order (to IP address 1 first, to IP address 8 last). [Destination port] Select a destination port of the Panasonic alarm protocol from the following. Available value: 1 - 65535 Default setting: 1818 ■ Panasonic alarm protocol [Destination IP address] Enter the destination IP address of the Panasonic alarm protocol from the following. Host name is unavailable for the IP address. Up to 8 destination addresses can be registered. To notify by Panasonic alarm protocol when an alarm occurred, check the "Alarm" checkbox respective to the desired address. To provide notification using Panasonic alarm protocol when any of the following has occurred, check the "Diag." checkbox respective to the desired address. • When notification of the remaining space of the SD memory card has been provided (☞ page 19) • When the SD memory card has become full • When mounting of the SD memory card has failed To delete the registered address, click the [DEL] button respective to the desired address. Important: Confirm that the destination IP addresses are registered correctly. When a registered IP address does not exist, notification may be delayed. [Retry times] Select a retry time of Panasonic alarm protocol. Available value: 1 - 30 Default setting: 2 33