Pfaff performance 5.2 Manual - Page 51
Buttonholes
View all Pfaff performance 5.2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Buttonholes Buttonholes are found in category 1, subcategory 1.3 in the selection menu. Note: Buttonholes up to 50mm can be sewn using the Sensormatic buttonhole foot 5A. Both sides of the Sensormatic buttonhole are sewn in the same direction for a more even result. Buttonholes over 50mm are sewn manually in four steps with presser foot 5M. The direction of the stitches being sewn will be indicated on the screen by an arrow next to the buttonhole. To sew a buttonhole, first attach the correct foot, then select your buttonhole. To ensure a good result, start with sewing a test sample on the fabric and stabilizer you will use. Note: Make sure that the IDT™ system is disengaged. Attaching the Sensormatic buttonhole foot 1. Snap on the Sensormatic buttonhole foot. A 2. Plug the cord into the socket found to the left above the needle area, behind the needle threader (A). Sensormatic buttonhole When you sew a buttonhole with the Sensormatic buttonhole foot, adjust the slit length so that it is slightly larger than the size of the button. You can measure your button using the button ruler on the lid. Set the slit length and make sure that the red arrow lines up with the marking on the foot (B). Start sewing by pressing the foot control or start/ stop button. The buttonhole will be completed automatically and the threads are cut. You can repeat the buttonhole as many times as you wish. Slit length Sewing mode B 4:15