Pfaff performance 5.2 Manual - Page 76
Cleaning the machine, Non-original parts and accessories
View all Pfaff performance 5.2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Cleaning the machine To keep your sewing machine operating well, clean it often. No lubrication (oiling) is needed. Wipe the exterior surface of your machine with a soft cloth to remove any dust or lint built up. Note: Use of cleaners or solvents on the machine can cause damage to the plexifront. Cleaning the bobbin area Note: Lower the feed dogs by pressing foot up and extra lift. Turn off the machine. Remove the presser foot and slide off the bobbin cover. Place the screwdriver under the needle plate as shown in the picture and gently turn the screwdriver to pop off the needle plate. Clean the feed dogs with the brush found with the accessories. Cleaning under the bobbin area Clean the area under the bobbin case after sewing several projects or any time you notice an accumulation of lint in the bobbin case area. Remove the bobbin case holder (A) covering the front part of the bobbin case by lifting it up. Remove the bobbin case (B) by lifting it up. Clean with the brush. Note: Use caution when cleaning around the thread snips knife (C). Put the bobbin case and the bobbin case holder back in place. Note: Do not blow air into the bobbin case area. The dust and lint will be blown into your machine. B C A Replacing the needle plate D With feed dogs lowered, place the needle plate with the knob fitting into the notch at the back (D). Press the needle plate down until it clicks into place. Slide on bobbin cover. Non-original parts and accessories The warranty does not cover any defect or damage caused by use of non-original accessories or parts. 8:2 Maintenance