Philips PXG30 User Manual - Page 41

12. Maintenance Lamp Replacement When the life of the Projection Lamp of this projector draws to an end, the Lamp Indicator lights yellow. If this indicator lights yellow, replace the projection lamp with a new one promptly. Lamp Replacement Top Control CAUTION For continued safety, replace with a lamp assembly of the same type. Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury. Cool the projector down, for at least 45 minutes before opening the Lamp Cover. The inside of the projector can become very hot. Follow these steps to replace the lamp assembly. 1 Turn off the projector and disconnect the AC plug. Allow the projector to cool for at least 45 minutes. 2 To remove the Lamp Cover, unscrew the screw with a screwdriver. 3 Loosen 2 screws with a screwdriver and pull out the Lamp Assembly by grasping Handle. 4 Replace the Lamp Assembly with a new one and tighten the 2 screws back into position. Make sure that the Lamp Assembly is set properly. Replace Lamp Cover and tighten the screw. 5 Connect AC power cord to the projector and turn on the projector. 6 Reset the Lamp Replace Counter. Refer to "Lamp Replace Counter Reset" on the next page . Lamp Cover Screws This indicator lights yellow when the life of the projection lamp draws to an end. Replace the Projection Lamp with a new one promptly. Screw Handle Lamp Assembly Order Replacement Lamp Replacement Lamp can be ordered through your dealer. Give the following information to the dealer when you order. - Model No. of your projector : LC1345 or LC1341 - Replacement Lamp Type No. : LCA3121/00(250W), 12nc: 8670 931 21009 (Service Parts No. 610 301 7167) 41