Pioneer DEH-P800PRS Owner's Manual - Page 58

Section 13 Audio Adjustments Initial (initial)-Custom (custom)-Auto TA (auto-time alignment)-TA OFF (off) ! Initial is the factory supplied time alignment. ! Custom is an adjusted time alignment that you can create for yourself. ! Auto TA is the time alignment created by auto TA and EQ. (Refer to Auto TA and EQ (auto-time alignment and auto-equalizing) on page 66.) # Please set Auto TA appears. This indicates that you cannot select Auto TA if auto TA and EQ has not been carried out. Adjusting the time alignment You can adjust the distance between each speaker and the selected position. ! An adjusted time alignment is memorized in Custom. 1 Use MULTI-CONTROL to select TA 1. TA1 appears in the display. 2 Press MULTI-CONTROL to select a unit of distance. Each press of MULTI-CONTROL selects the unit of distance in the following order: (cm) (centimeter)-(inch) (inch) 3 Use MULTI-CONTROL to select TA2. TA2 appears in the display. # Can't Adjust TA. Set POS FL/FR appears when neither Front Left nor Front Right is selected in the position selector mode (POSI). # When selecting TA OFF in TA1, you cannot switch to TA2. 4 Push MULTI-CONTROL left or right to select the speaker to be adjusted. Each time MULTI-CONTROL is pushed left or right, the speaker is selected in the following order: Hi L (high-range left)-Hi R (high-range right) -Mid L (middle-range left)-Mid R (middlerange right)-Low L (low-range left)-Low R (low-range right) Front L (front left)-Front R (front right)- Rear R (rear right)-Rear L (rear left)- SubW. L (subwoofer left)-SubW. R (subwoofer right) # You cannot select SubW. L and SubW. R when the subwoofer output is off. 5 Push MULTI-CONTROL up or down to adjust the distance between the selected speaker and the listening position. Each time MULTI-CONTROL is pushed up or down, the distance increases or decreases. 400.0cm to 0.0cm is displayed as the distance is increased or decreased, if you have selected centimeters ((cm)). 160inch to 0inch is displayed as the distance is increased or decreased, if you have selected inches ((inch)). # You can adjust the distance for the other speakers in the same way. 6 Press BAND to cancel the time alignment mode. About the network function The network function lets you divide the audio signal into different frequency bands, and then reproduce each of them through separate speaker units. You can then make precise adjustments to the reproduced frequency band (with a low-pass filter or high-pass filter), level, phase and other parameters to match the characteristics of each speaker unit. 58 En