Pioneer PDP-5070HD Owner's Manual - Page 24
When using the hung on wall unit - plasma display
View all Pioneer PDP-5070HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
05 Preparation When using the hung on wall unit: First install the Plasma Display on the wall with only the speaker mounting fittings and speaker cable attached to the display, and then attach the speaker. 1. Connect the supplied speaker cables to the back of the Plasma Display. 2. Place the Plasma Display on the mounting fittings of the hung on wall unit. For details, refer to the instruction manual supplied with the hung on wall unit. 3. Connect the other end of the speaker cables to the speaker. 4. Place the speaker on the speaker mounting fittings in the correct direction. * Speaker mounting screw (M5 x 10 mm) * Speaker mounting screw (M5 x 10 mm) 5. Tighten from below using the supplied screws (3 locations). Attach the speaker in the center first, and then both sides with the supplied screws. CAUTION • Be careful not to be injured by the speaker mounting fittings 24 during installation or cable wiring. En * Speaker mounting screw (M5 x 10 mm) The screw hole at the bottom of the speaker mounting (indicated with an asterisk) is not used when the Plasma Display is installed on the wall.