Pioneer PDP-5070HD Owner's Manual - Page 76
Computer compatibility chart, G-LINK™ connection
View all Pioneer PDP-5070HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
12 Enjoying through External Equipment Computer compatibility chart Resolution 720 × 400 640 × 480 800 × 600 1024 × 768 1360 x 768 Frequency 70 Hz 60 Hz 72 Hz 75 Hz 56 Hz 60 Hz 72 Hz 75 Hz 60 Hz 70 Hz 75 Hz 60 Hz G-LINK™ connection You need to make this connection, so that the TV Guide On Screen™ system works with the Plasma Display System to enable the system's recording features with your VCR. NOTE • In order to use your VCR with the TV Guide On Screen™ system, you have to correctly set up for the TV Guide On Screen™ system. See "TV Guide On Screen™ System Setup" on page 38. • Make sure to position the G-LINK cable's wand so that its light emitting section faces the remote control sensor on the VCR. • Make sure to place the VCR into the standby status when presetting TV programs for recording with the TV Guide On Screen™ system. • Be careful not to leave the cable looped when making the connection. Attaching the ferrite core To help prevent noise, attach the supplied ferrite core to the connector end of the G-LINK cable as shown. Ferrite core G-LINK cable Pull the cable slightly to take up any slack A . A As close as possible CAUTION • Regarding the G-LINK cable, attach the supplied ferrite core. If you do not do this, this Plasma Display will not conform to mandatory FCC standards. When connecting the VCR Plasma Display (rear view) Viewed from below of the Plasma Display AV cable (commercially available) G-LINK cable (supplied) G-LINK cable's wand Point to the remote VCR control sensor 76 En