Pioneer PDP-5070HD Owner's Manual - Page 27
English, Step 4, Step 3 - table stand
View all Pioneer PDP-5070HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Preparation 05 English 2 With the Plasma Display lying flat, insert and secure the two installation bolts ➁ (M8 x 20 mm: black) in the holes "a" located in center of the Plasma Display housing. • At this point, tighten these bolts ➁ only until the threads are no longer visible when viewed from the side (you will be unable to attach the display if the bolts are screwed in completely). Installation bolt ➁ Plasma Display housing Stop screwing down the bolt when the threads are no longer visible. Installation bolts ➁ (M8 x 20 mm: black) Holes "a" (holes in center of Plasma Display) 4 Pass the installation bolts ➀ (M8 x 40 mm: black) through the stand pipes and tighten the installation bolts firmly using the enclosed hexagonal wrench. (The holes should be used in the proper combinations, "B" - "B"). 5 Tighten the installation bolts ➁ firmly using the enclosed hexagonal wrench. Installation bolts ➀ (M8 x 40 mm: black) (Step 4) Slide the stand (Step 3) Plasma Display Sheet • Make sure to remove the speaker mounting fittings. NOTE • When lying the Plasma Display down, be careful not to scratch or damage it. B A BA´´ B A BA´´ Table top stand 6 Replace the Plasma Display to stand upright. • For speaker installation, see "Installing the PIONEER speaker" on page 20. NOTE • Insert the bolts in the holes vertically and do not tighten them with more force than necessary. • Place a sheet or protective cover to protect the display from scratches or damage. • Work only with the Plasma Display lying flat on a table or similar surface. • Move the stand so that the stand screw holes and the nuts that connect the main display line up correctly. 3 As shown in the above figure, hook the stand pipe holes (pipe "B") onto the screw heads of the installation bolts ➁, then slide the stand upwards to the main Plasma Display until it engages the installation bolts ➁ (once put together with the display, the stand will slide no more than 19 mm (3/4 inch)). 27 En