Pioneer SC-LX904 11.2 Channel AV Receiver Owners Manual-English - Page 125
Playing Back (ZONE 3)
View all Pioneer SC-LX904 11.2 Channel AV Receiver manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Playing Back (ZONE 3) Contents ≫ Connections ≫ Playback ≫ Setup ≫ In the remote controller operation, while pressing and holding the ZONE 3 button on the remote controller, operate with each button. 1. Point the remote controller at the unit, and while pressing and holding the ZONE 3 button on the remote controller, press . • "Z3" on the display of the main unit lights up. 2. While pressing and holding the ZONE 3 button on the remote controller, press the input selector of the input source you want to play in the separate room. When operating on the main unit, press the ZONE CONTROL button repeatedly to select "Z3" on the display, then within 8 seconds select the input you want to play in another room using the input selector dial. 3. If the unit is connected to the pre-main amplifier in the separate room, adjust the volume on the pre-main amplifier. If the unit is connected to the power amplifier or ZONE speaker in the separate room, adjust the volume with the volume button while pressing and holding the ZONE 3 button on the remote controller. When operating on the main unit, press the ZONE CONTROL button repeatedly to select "Z3" on the display, then within 8 seconds adjust using the MASTER VOLUME knob. • When connecting the power amplifier, set "Multi Zone" - "Zone 3" - "Output Level" ( p175) to "Variable" on the System Setup menu. If it is not set, a large volume is output and the power amplifier, speakers, etc. may be damaged. • If you turn the unit to standby during multi-zone playback, the Z3 indicator is dimmed, and the playback mode is switched to playback in a separate room only. Setting ZONE 3 to on while the unit is in standby also switches the playback mode to playback in a separate room only. • For ZONE 3 output, audio from externally connected AV components can be output only when it is an analog audio signal. • DSD audio signals cannot be output to ZONE 3 when selected with the "NET" or "USB" input selector. • If ZONE 3 is on, power consumption during standby will increase. To set the function to off: While pressing and holding ZONE 3 button, press . Alternatively, press the ZONE 3 ON/OFF button on the main unit. 125 Front Panel≫ Rear Panel≫ Remote≫