Pioneer SC-LX904 11.2 Channel AV Receiver Owners Manual-English - Page 200

Contents ≫ Connections ≫ Playback ≫ Setup ≫ (digital analog converter). You can choose "Slow" (gives the sound a soft and fluid feel), "Sharp" (gives the sound more structure and firmer feel), or "Short" (gives the sound a feeling of a quick start and moving forward). The setting can be separately set to each input selector. This can be set when the sampling frequency is 44.1 kHz or more. • This cannot be set if "Auto" is selected for "Audio Scalar". Reflex Optimizer : Enhance the reflection effect of Dolby enabled speakers from the ceiling. • This setting can be selected when "System Setup" - "Speaker" - "Configuration" - "Height 1 Speaker"/"Height 2 Speaker" is set to "Dolby Speaker". • It cannot be set if the listening mode is Pure Direct. „„MCACC MCACC EQ: Enable or disable the equalizer function that corrects for distortion caused by the acoustic environment of the room. • It cannot be set if the listening mode is Pure Direct. Phase Control: Correct phase disturbance in the low range to enhance the bass. This enables you to achieve powerful bass reproduction that is faithful to the original sound. • It cannot be set if the listening mode is Pure Direct. When "Phase Control" is set to "Full Band": Along with the Phase Control function, the Full Band Phase Control function is also enabled. The Full Band Phase Control function corrects for group delay (the difference between phase and timing) between speakers when speaker units are divided into multiple parts, such as tweeter and woofer sections, and furthermore it lines up the phases of the connected speakers so the unit can achieve more accurate reproduction across the full range (full band) and across all channels. Furthermore, if the "Front Align" calibration type has been selected and Full Auto MCACC was performed, the phases of speakers other than the front speakers are corrected to match the frequency phase characteristics of the front speakers. • "Full Band" cannot be selected if Full Auto MCACC has not been performed. MCACC Memory : From MCACC Memory 1 to 3 where speaker settings calibrated with "Full Auto MCACC" or "Manual MCACC" are saved, select which Memory to use. Theater Filter: Adjust the soundtrack that was processed to enhance its high pitch range, in order to make it suitable for home theater. • It cannot be set if the listening mode is Direct or Pure Direct. Standing Wave: Setting this "On" will control the effect of the standing wave generated by the sound wave reflected by wall or similar interfering with the original sound wave. • It cannot be set if the listening mode is Pure Direct. „„Level Front: Adjust the speaker level of the front speaker while listening to the sound. Center: Adjust the speaker level of the center speaker while listening to the sound. Subwoofer 1 / Subwoofer 2 : Adjust the speaker level of the subwoofer while listening to the sound. • If you set the unit to the standby mode, the adjustments you made will be restored to the previous statuses. 200 Front Panel≫ Rear Panel≫ Remote≫