Pioneer SC-LX904 11.2 Channel AV Receiver Owners Manual-English - Page 85
Connecting a Pre-main Amplifier (ZONE 2
View all Pioneer SC-LX904 11.2 Channel AV Receiver manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Contents ≫ Connections ≫ Playback ≫ Setup ≫ Connecting a Pre-main Amplifier (ZONE 2) You can enjoy 2-ch audio in the separate room (ZONE 2) while performing playback in the main room (where this unit is located). Connect the ZONE 2 PRE/ ARC eARC 5 V 500 mA LINE OUT jacks of the unit and the LINE IN jacks of the pre-main amplifier or 4K HDR HDMI OUT 4K HDR USB power amplifier in a separate room with an analog audio cable. The same source can be played back in the main room and ZONE 2 simultaneously. Also, different sources can be played back in both rooms. • To output audio from an externally connected AV component to ZONE ZONE B 2, connect it to any of HDMI IN1 to IN3 jacks. If the AV component is not (LINE OUT) equipped with an HDMI jack, use a digital coaxial cable, digital optical cable or analog audio cable. Also, the audio from externally connected AV components can be output to ZONE 2 only when the audio is analog or 2ch PCM signal. When the AV component is connected to this unit with a digital coaxial cable or digital optical cable, change the audio output of the AV component to the PCM output. a Setup • Settings are required to output audio to ZONE 2. Press on the remote controller to display the Home screen, then set "System Setup" - "Speaker" - "Configuration" - "Zone 2 Preout" ( p159) to "Zone 2". LINE • When connecting the power amplifier, set "Multi Zone" - "Zone 2" - "Output IN Level" ( p174) to "Variable" on the System Setup menu. If it is not set, a large volume is output and the power amplifie, speakers, etc. may be damaged. Premain Amp. a Analog audio cable 85 Front Panel≫ Rear Panel≫ Remote≫