Ricoh Aficio SP 4310N Manuals - Page 195
For details, see Registering Classification Codes, Software Guide., Ethernet Board Error
View all Ricoh Aficio SP 4310N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 195 highlights
Error and Status Messages Appear on the Control Panel Cannot connect with DHCP server.(101/201) Cannot obtain IP address from DHCP server. Consult your network administrator. Cannot connect with NetWare print server. (107/207) Connection with NetWare print server is unavailable. Cannot connect with NetWare server.(106/206) Connection with NetWare server is unavailable. Consult your network administrator. Cannot print. Check the file you want to print is a supported file type. Check for misfeeds and ask your network administrator for help. Check network settings.(103/203) The IP address setting is incorrect. Check the IP address, subnet mask, and gateway address. For details, see p.85 "Ethernet Configuration". Classification Code Error A classification code is not specified for the print job. Enter a classification code using the printer properties and print the document again. For details, see "Registering Classification Codes", Software Guide. Connect failed:WirelessCard Turn power off, check card. Check there is a Wireless LAN board installed. Check that it is a supported board. If it is, check it is installed correctly. Install the correct board properly. For details, see p.64 "Installing the Interface Units". Cover Open. Please close the indicated cover. 9 Close the cover indicated on the control panel. Duplex mode is in off position for (tray name) The duplex mode for the indicated tray is off; you can only use one-sided printing. Press [Change] to change the tray's settings, press [JobReset] to reset the job, or press [Form Feed] to force printing. Ethernet Board Error An error on the Ethernet board is detected. Pull out and then re-install the controller board. If the problem persists, contact your sales or service representative. Exceeded max. print size. Press [FormFeed] or [JobReset]. The specified paper size exceeds the maximum size supported by this printer. Press [Form Feed] to force printing or [JobReset] to cancel printing. 193