Ricoh C410DN Hardware Guide - Page 109
Loading Paper in the Bypass Tray, Plain Paper, Maintenance, General Settings, Plain, Paper
UPC - 026649025341
View all Ricoh C410DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Loading Paper Note ❒ If the printing result is wet or smudged with the [Plain Paper] setting, Make the following settings using the control panel: • Select [Plain Paper] for the paper type according to the procedure above. • Press the {Menu} key, select [Maintenance], [General Settings], and [Plain Paper]. Select the tray you want to set, and then select [Plain Paper 1] or [Plain Paper 2]. ❒ The following paper types cannot be printed on both sides: • Special Paper, Label Paper, Cardstock, OHP (Transparency), Thick Paper 2 (157 - 209.4 g/m2), Thin Paper, Plain:Dup.Back (reverse side of plain paper), Thick1:Dup.Back (reverse side of thick paper), Thick2:Dup.Back Loading Paper in the Bypass Tray Important ❒ Shuffle the paper before loading the stack onto the tray, so multiple sheets are 5 not fed in together. ❒ Set the size and direction of the loaded paper on the control panel or with the printer driver. Make sure the settings do not conflict. Otherwise, the paper may jam or the print quality may be affected. ❒ Load paper with the print side down and in the short-edge feed direction. A Press the mark in the centre of the bypass tray. AQC002S Open the bypass tray. AQC003S 97