Ricoh C410DN Software User Guide - Page 234
sntp, spoolsw, Configuring SNMP v3 encryption, View settings, NTP server address configuration
UPC - 026649025341
View all Ricoh C410DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 234 highlights
Monitoring and Configuring the Printer ❖ Configuring SNMP v3 encryption msh> snmp v3priv {auto|on} • Set "auto" for automatic encryption configuration • Set "on" for mandatory encryption configuration. sntp The printer clock can be synchronized with a NTP server clock using Simple Network Time Protocol (SNTP). Use the "sntp" command to change SNTP settings. ❖ View settings msh> sntp ❖ NTP server address configuration You can specify the IP address of the NTP server. msh> sntp server "IP_address" ❖ Interval configuration 6 msh> sntp interval "polling_time" • You can specify the interval at which the printer synchronizes with the op- erator-specified NTP server. The default is 60 minutes. • The interval can be entered from 0, or between 16 and 10,080 minutes. • If you set 0, the printer synchronizes with the NTP server only when you turn the printer on. After that, the printer does not synchronize with the NTP server. ❖ Time-zone configuration msh> sntp timezone "+/-hour_time" • You can specify the time difference between the printer clock and NTP server clock. The values are between -12:00 and +13:00. spoolsw Use the "spoolsw" command to view and configure Job Spool settings. You can only specify diprint, lpr, ipp, ftp, smband sftp protocol. • The "spoolsw" command for configuring Job Spool settings is available only when the optional hard disk is installed. ❖ View settings The Job Spool setting appears. msh> spoolsw ❖ Job Spool setting msh> spoolsw spool {on | off} 222