Ricoh C410DN Software User Guide - Page 241
wins, msh> wins interface_name {primary|secondary} IP ad
UPC - 026649025341
View all Ricoh C410DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 241 highlights
Remote Maintenance by telnet wins Use the "wins" command to configure WINS server settings. ❖ Viewing settings msh> wins • If the IPv4 address obtained from DHCP differs from the WINS IPv4 address, the DHCP address is the valid address. ❖ Configuration msh> wins "interface_name" {on | off} • {on} means "active" and {off} means "inactive". • Be sure to specify the interface. • wlan can be specified only when the IEEE 802.11b interface is installed. Interface name Interface configured ether Ethernet interface wlan IEEE 802.11b interface 6 ❖ Address configuration Use the following command to configure a WINS server IP address: msh> wins "interface_name" {primary|secondary} "IP address" • Use the "primary" command to configure a primary WINS server IPv4 address. • Use the "secondary" command to configure a secondary WINS server IPv4 address. • Do not use "255.255.255.255" as the IPv4 address. ❖ NBT (NetBIOS over TCP/IP) Scope ID Selection You can specify the NBT scope ID. msh> wins "interface_name" scope "scope ID" • The scope ID can be entered using up to 31 alphanumeric characters. • Be sure to specify the interface. • wlan can be specified only when the IEEE 802.11b interface is installed. Interface name ether wlan Interface configured Ethernet interface IEEE 802.11b interface 229