Ricoh IM 430F User Guide - Page 20
Connecting and Setting the Network, Setting Wired LAN, Connecting Ethernet Interface
View all Ricoh IM 430F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
1. Getting Started Connecting and Setting the Network Setting Wired LAN Connecting Ethernet Interface This section describes how to connect an Ethernet interface cable to the Ethernet port. If you use an Ethernet interface cable that supports 1000BASE-T, set [Ethernet Speed] to [Auto Select: Enable 1Gbps] in [Interface Settings] in [System Settings]. • Use the following Ethernet cables. • When using 100BASE-TX/10BASE-T: Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5 or more • When using 1000BASE-T: Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5e or more • When you use IPv6, set [Effective Protocol] to [Active] in [Interface Settings] in [System Settings]. IPv6 is inactive as a factory default. When you enable IPv6, a link-local address is automatically set. • To use IPv6, consult your network administrator. 1. Make sure the main power is switched off. 2. Connect the Ethernet interface cable to the Ethernet port. DVL802 3. Connect the other end of the Ethernet interface cable to a network connection device such as a hub. 18