Ricoh IM 430F User Guide - Page 247

Messages Displayed on the Control Panel When You Use the Scanner Function When the WSD scanner function cannot be used Message Cause Solution "Cannot communicate with PC. Contact the administrator." WSD (Device) protocol or WSD (Scanner) protocol is disabled. For details about how to enable or disable the WSD protocol, see "Enabling and Disabling Protocols", Security. "Cannot start scanning Scan Profile is not set on the because communication was client computer. failed." Set Scan Profile. For details about how to do this, see "Creating a New Scan Profile", Scan. "Cannot start scanning because communication was failed." The [Take no action] setting has been selected on the client computer, forcing the client computer to remain inactive when it receives scan data. Open scanner properties, click the [Events] tab, and then select [Start this program] as the computer's response when it receives scan data. For details, see your operating system's Help. "Cannot start scanning. Check the setting(s) on the PC." The Scan Profile might be incorrectly configured. Check the Scan Profile configuration. "Could not send the data because the PC timed out before it was sent." A time out occurred when WSD Scanner was used. Time outs occur when too much time passes between scanning an original and sending its data. The followings are likely causes of time outs: • Too many originals per set. • Misfed originals. • Transmission of other jobs. • Reduce the number of originals, and then scan again. • Remove any misfed original, and then scan again. • Use Scanner Journal to check there are no jobs awaiting transmission, and then scan again. 245