Sharp HT-X1 HT-X1 Operation Manual - Page 21

HT-X1 " Speaker connection Make sure to leave the AC power cord disconnected when connecting the speakers. To prevent accidental short-circuits between and terminals, connect the speaker wires to the speakers first and then to the subwoofer/amplifier unit. When connecting speakers, match the colors of the back label on the speaker, to the tube for the speaker wire, and speaker terminal of the subwoofer/amplifier unit. 1 Connect the wires to the speakers. Example: To connect the left front speaker. Label (white) Red Tube (white) Caution: ! The supplied speakers are exclusively for the HT-X1. Do not connect them to other equipment, and do not connect other speakers to the HT-X1. It may cause malfunction. ! Do not mistake the and , and right and left terminals of the speaker wires. (The right speaker is placed on the right when you face the subwoofer/amplifier unit.) ! Do not stand or sit on the speakers. You may be injured. ! Do not allow any objects to fall into or to be placed in the bass reflex ducts of the subwoofer/amplifier unit. ! The speaker grilles are not removable. ! Do not short-circuit the speaker wire. If it happens with the power on, the protection circuit is activated and the system enters the stand-by mode. In this case, check that the speaker wire is connected correctly before turning on the power again. Incorrect Preparation for Use Black 2 Connect the other end to the subwoofer/amplifier unit. Black Subwoofer/ amplifier unit Tube (white) Red Speaker terminal (white) " Attaching the optional floor speaker stand The front speakers and surround speakers support the optional floor speaker stand (see page 65). Remove the original stand for each speaker using a screwdriver first. For details, refer to the manual for the floor speaker stand. Note: Keep the removed speaker stands or screw in a safe place. 21