Sharp HT-X1 HT-X1 Operation Manual - Page 26

Preparation for Use HT-X1 26 Remote control " Battery installation Use 2 "AAA" size batteries (UM-4, R03, HP-16 or similar). Batteries are not included. 1 Remove the battery cover. 2 Insert the batteries according to the direction indicated in the battery compartment. When inserting or removing the batteries, push them toward the battery terminals. 3 Replace the cover. Notes concerning use: ! Replace the batteries if the operating distance is reduced or if the operation becomes erratic. ! Periodically clean the transmitter on the remote control and the sensor on the main unit with a soft cloth. ! Exposing the sensor on the main unit to strong light may interfere with operation. Change the lighting or the direction of the main unit if this occurs. ! Keep the remote control away from moisture, heat, shock, and vibrations. " Test of the remote control Check the remote control after checking all the connections (see pages 19 - 25). Point the remote control directly at the remote sensor on the main unit. The remote control can be used within the range shown below: Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy music. ! The main unit is equipped with 2 remote sensors. Use them according to the installation method as shown below. Precautions for battery use: ! Replace all old batteries with new ones at the same time. ! Do not mix old and new batteries. ! Remove the batteries if the system will not be used for long peri- ods of time. This will prevent potential damage due to battery leakage. Caution: ! Do not use rechargeable batteries (nickel-cadmium battery, etc.). ! Installing the batteries incorrectly may cause the system to mal- function. Main unit Remote sensor 8"-20' (0.2 m - 6 m) Battery removal: Remove the battery cover. Push each battery toward the battery terminal and take them out.