Sonos ZP80 User Guide - Page 23
If you are connecting a ZonePlayer 100, Do not connect speakers rated at less than 4 Ohms. - flashing white light
View all Sonos ZP80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Chapter 2: ZonePlayer Setup and Operation 2-5 If you are connecting a ZonePlayer 100 Once you have connected the ZonePlayer to your home network, follow the steps below to attach speakers to the ZonePlayer 100, and then apply power. Your speaker's power rating should be at least 75W for 8 Ohm speakers, and at least 150W for 4 Ohm speakers. Do not connect speakers rated at less than 4 Ohms. Note: Connect the red (+) and black (-) terminals from each speaker to the corresponding terminals on the ZonePlayer. Mismatching of polarities will result in weak central sound, and a distorted sense of sound direction. 1. When making connections, ensure that none of the strands of your speaker wire come in contact with an adjoining terminal on the rear panel. 2. Use your thumb or finger to firmly push the springloaded speaker connector post inward to reveal the connection hole. 3. Insert the stripped end of the speaker wire into the hole, then release. The stripped portion should be caught firmly in the connector post. 4. Repeat to install the other speaker wires. 5. Attach the power cord and plug into a wall outlet. The Mute button indicator and the ZonePlayer Status indicator will begin to flash. (If this ZonePlayer was previously connected to another Sonos Digital Music System, the ZonePlayer Status indicator may light solid white instead.)