Sony HDR UX1 Operating Guide - Page 31

z Tips • If you attach the battery pack or connect the AC Adaptor when the POWER switch is set to OFF (CHG), your camcorder turns on, then off again, after a few seconds. To remove the battery pack Slide the POWER switch to OFF (CHG). Slide the BATT (battery release) lever and remove the battery pack. After a while, the approximate recordable time in the selected format and battery information appear for about 7 seconds. You can view the battery information for up to 20 seconds by pressing DISP/BATT INFO again while the information is displayed. Remaining battery (approx.) Getting Started BATT (battery release) lever b Notes • When you remove the battery pack, make sure that the (Movie) lamp/ (Still) lamp (p. 33) is turned off. When storing the battery pack Fully discharge the battery before storing it for an extended period (see page 134 for the details of storage). To use an outside power source Make the same connections as you do when charging the battery pack. The battery pack will not lose its charge in this case. To check the remaining battery (Battery Info) Set the POWER switch to OFF (CHG), then press DISP/BATT INFO. Recording capacity (approx.) Charging time Approximate time (min.) required when you fully charge a fully discharged battery pack. Battery pack Charging time NP-FM50 150 (supplied) NP-QM71D 260 NP-QM91D 360 Recording time Approximate time (min.) available when you use a fully charged battery pack. HD (high definition) image quality Battery pack NP-FM50 (supplied) NP-QM71D Continuous recording time 90 95 95 225 235 235 Typical recording time* 50 50 50 120 125 125 Continued , 31