Sony HT-SS380 Operating Instructions - Page 49

Specifications, Reference s, AUDIO POWER

Get Sony HT-SS380 PDF manuals and user guides
UPC - 027242808317
View all Sony HT-SS380 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 49 highlights

Error messages If there is a malfunction, a message appears on the display panel. You can check the condition of the system by the message. If any problem persists, consult your nearest Sony dealer. If an error message appears while you perform Auto Calibration, see "When error codes appear" (page 27) to solve the problem. PROTECTOR Irregular current is output to the speakers, the volume level is too high, or the upper panel of the receiver is covered and ventilation holes are blocked. The receiver will automatically turn off after a few seconds. Check the speaker connection and remove the object covering the ventilation holes. Turn on the power and increase the volume level. Clearing the memory If you are unable to remedy the problem using the troubleshooting guide, clearing the receiver's memory may remedy the problem. However, note that all memorized settings will be reset to the default settings and you will have to readjust all settings on the receiver. Reference sections To clear All memorized settings See page 24 Specifications AUDIO POWER SPECIFICATIONS Amplifier section POWER OUTPUT AND TOTAL HARMONIC DISTORTION: (FTC) (USA model only) FRONT L + FRONT R With 3 ohm loads, both channels driven, from 180 - 20,000 Hz; rated 84 watts per channel minimum RMS power, with no more than 1% total harmonic distortion from 250 milliwatts to rated output. POWER OUTPUT (reference) FRONT L/FRONT R/CENTER/SUR L/SUR R 167 W (per channel at 3 ohms, 1 kHz) SUBWOOFER 165 W (at 3 ohms, 60 Hz) Inputs Analog Sensitivity: 1 V/50 kohms Digital (Coaxial) Impedance: 75 ohms FM tuner section Tuning range 87.5 MHz - 108.0 MHz (100 kHz step) Antenna FM wire antenna (aerial) Antenna terminals 75 ohms, unbalanced General Power requirements 120 V AC, 60 Hz Power output (DMPORT) DC OUT: 5 V, 1 A MAX Power consumption 110 W Power consumption (during standby mode) 0.3 W (When Control for HDMI is set to off) Additional Information continued 49US

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
49
US
Additional Information
If there is a malfunction, a message appears on
the display panel. You can check the condition
of the system by the message. If any problem
persists, consult your nearest Sony dealer.
If an error message appears while you perform
Auto Calibration, see “When error codes
appear” (page 27) to solve the problem.
PROTECTOR
Irregular current is output to the speakers,
the volume level is too high, or the upper
panel of the receiver is covered and
ventilation holes are blocked. The receiver
will automatically turn off after a few
seconds. Check the speaker connection and
remove the object covering the ventilation
holes.
Turn on the power and increase the volume
level.
If you are unable to remedy the problem using
the troubleshooting guide, clearing the
receiver’s memory may remedy the problem.
However, note that all memorized settings will
be reset to the default settings and you will
have to readjust all settings on the receiver.
Reference sections
Specifications
AUDIO POWER
SPECIFICATIONS
Amplifier section
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(FTC)
(USA model only)
FRONT L + FRONT R
With 3 ohm loads, both
channels driven, from 180
– 20,000 Hz; rated 84 watts
per channel minimum
RMS power, with no more
than 1% total harmonic
distortion from 250
milliwatts to rated output.
POWER OUTPUT (reference)
FRONT L/FRONT R/CENTER/SUR L/SUR R
167 W (per channel at
3 ohms, 1 kHz)
SUBWOOFER
165 W (at 3 ohms, 60 Hz)
Inputs
Analog
Sensitivity: 1 V/50 kohms
Digital (Coaxial)
Impedance: 75 ohms
FM tuner section
Tuning range
87.5 MHz – 108.0 MHz
(100 kHz step)
Antenna
FM wire antenna (aerial)
Antenna terminals
75 ohms, unbalanced
General
Power requirements
120 V AC, 60 Hz
Power output (DMPORT)
DC OUT:
5 V, 1 A MAX
Power consumption
110 W
Power consumption (during standby mode)
0.3 W (When Control for
HDMI is set to off)
Error messages
Clearing the memory
To clear
See
All memorized settings
page 24
continued