Sony MVCCD300 Operating Instructions - Page 89

On discs, Additional information, On the built-in rechargeable, lithium battery, On cleaning

Page 89 highlights

On the built-in rechargeable lithium battery Your camera is supplied with a built-in rechargeable lithium battery installed so as to retain the date and time, etc., regardless of the setting of the POWER switch. The built-in rechargeable lithium battery is always charged as long as you are using your camera. The battery, however, will get discharged gradually if you do not use your camera. It will be completely discharged in about one month if you do not use your camera at all. Even if the built-in rechargeable lithium battery is not charged, it will not affect the camera operation. To retain the date and time, etc., charge the battery if the battery is discharged. Charging the built-in rechargeable lithium battery: • Connect your camera to house current (mains) using the AC power adaptor supplied with your camera, and leave your camera with the power turned off for more than 24 hours. • Or install the fully charged battery pack in your camera, and leave your camera with the power turned off for more than 24 hours. If any problem occurs, unplug your camera and contact your nearest Sony dealer. On discs Be sure to use only 8 cm CD-Rs/CDRWs. You cannot read or write data on other type discs that do not correspond to this camera. On cleaning • Do not clean a disc using a cleaner before recording. Use a commercially available blower to remove dust. • If fingerprints, dust, drop of water, or oil makes the recordable side (the other side of the printed side) of a disc dirty, the camera may not properly record an image on the disc. You should handle a disc with a lot of care. • If a disc does become dirty, wipe it in a straight line from center to edge with a soft dry cloth or a soft cloth lightly moistened with a mild detergent solution. You can use a commercially available CD cleaner. Additional information • Do not use any solvent (benzine, thinner, static protection product, record cleaner, etc.) to clean a disc. Notes • Do not remove the disc while reading or writing data. 89

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108

89
Additional information
Your camera is supplied with a built-in
rechargeable lithium battery installed
so as to retain the date and time, etc.,
regardless of the setting of the POWER
switch. The built-in rechargeable
lithium battery is always charged as
long as you are using your camera. The
battery, however, will get discharged
gradually if you do not use your
camera. It will be completely
discharged in about one month if you
do not use your camera at all. Even if
the built-in rechargeable lithium
battery is not charged, it will not affect
the camera operation. To retain the
date and time, etc., charge the battery if
the battery is discharged.
Charging the built-in rechargeable
lithium battery:
Connect your camera to house
current (mains) using the AC power
adaptor supplied with your camera,
and leave your camera with the
power turned off for more than 24
hours.
Or install the fully charged battery
pack in your camera, and leave your
camera with the power turned off for
more than 24 hours.
If any problem occurs, unplug your
camera and contact your nearest Sony
dealer.
On discs
Be sure to use only 8 cm CD-Rs/CD-
RWs. You cannot read or write data on
other type discs that do not correspond
to this camera.
Do not clean a disc using a cleaner
before recording. Use a
commercially available blower to
remove dust.
If fingerprints, dust, drop of water, or
oil makes the recordable side (the
other side of the printed side) of a
disc dirty, the camera may not
properly record an image on the disc.
You should handle a disc with a lot of
care.
If a disc does become dirty, wipe it in
a straight line from center to edge
with a soft dry cloth or a soft cloth
lightly moistened with a mild
detergent solution. You can use a
commercially available CD cleaner.
Do not use any solvent (benzine,
thinner, static protection product,
record cleaner, etc.) to clean a disc.
Notes
Do not remove the disc while reading or
writing data.
On the built-in rechargeable
lithium battery
On cleaning