Sony STR-DA3700ES Operating Instructions - Page 129
Audio, When you select My Video, My
View all Sony STR-DA3700ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
• Set "Auto Standby" to "Off" (page 107). While only composite video signals are being recorded, the auto standby function of the receiver may start up and interrupt the recording. Specific type of image is not output or corrupted. Component video output • The resolution of output signals from the COMPONENT VIDEO OUT jacks may not be supported by your TV. In this case, select the appropriate resolution on the receiver (page 100). • COMPONENT VIDEO MONITOR OUT jacks have restrictions on resolution when the resolution of video signals protected by copyright technology is converted. The resolution of the signals output to the COMPONENT VIDEO MONITOR OUT jacks is converted up to 480p/576p. HDMI output • Be sure to use a connecting cable for the HDMI jack corresponding to High Speed HDMI cable when you view images or listen to sound, especially for the 1080p, Deep Color, or 3D transmission. 3D image • Depending on the TV or the video equipment, 3D images may not be displayed. Check the 3D image formats supported by the receiver (page 139). VCR • If you use a VCR without an image improvement circuit, such as TBC, the images may be distorted. When you select "My Video," "My Music," "My Photo," "Internet Video," "Internet Music," "Internet Photo," "Internet Network," or "Sony Entertainment Network" from the Watch/Listen menu, no picture is output. • Select "BD/DVD" using INPUT SELECTOR on the receiver once, then set "Playback Resolution" to "480p/576p" in the Video Settings menu using the GUI (page 101), and select the content again. Audio There is no sound, no matter which equipment is selected, or only a very low-level sound is heard. • Check that the speakers and equipment are connected correctly. • Check that both the receiver and all equipment are turned on. • Check that MASTER VOLUME control is not set at -∞ dB. Try to set it at about -40 dB. • Check that SPEAKERS (A/B/A+B/OFF) is not set to OFF (page 10). • Press MUTING on the remote control to cancel the muting function. • Try pressing the input button on the remote control or INPUT SELECTOR on the receiver to select the equipment of your choice. • Check that headphones are not connected. • When you want to listen to the sound from the TV speaker, set "Audio Out" to "TV+AMP" in the HDMI Settings menu. If set to "AMP," the sound is not output through the TV speaker. If you output the multi-channel sound from the receiver, set to "AMP." • Sound may be interrupted when the sampling frequency, the number of channels or audio format of audio output signals from the playback equipment is switched. • Set the "EQ" setting of the iPhone/iPod to "Off" or "Flat." There is severe hum or noise. • Check that the speakers and equipment are connected correctly. • Check that the connecting cords are away from a transformer or motor, and at least 3 meters away from a TV set or fluorescent light. continued 129US Additional Information