Sony STR-DA3700ES Operating Instructions - Page 43
: Preparing the receiver and the remote control, To save the power in standby
View all Sony STR-DA3700ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Getting Started 6: Preparing the receiver and the remote control Connecting the AC power cord (mains lead) Connect the supplied AC power cord (mains lead) to the AC IN terminal on the receiver firmly, then connect the AC power cord (mains lead) to a wall outlet. AC IN terminal To the wall outlet AC power cord (mains lead) (supplied) A several space is left between the plug and the rear panel even when the power cord (mains lead) is inserted firmly. The cord is supposed be connected this way. This is not malfunction. Turning on the receiver ?/1 Press ?/1 to turn on the receiver. You can also turn on the receiver using ?/1 on the remote control. When you turn off the receiver, press ?/1 again. "STANDBY" flashes on the display window. Do not disconnect the AC power cord (mains lead) while "STANDBY" is flashing. This may cause a malfunction. To save the power in standby mode Set "Control for HDMI" (page 103), "Pass Through" (page 103), "Network Standby" (page 105) and "RS232C Control" (page 108) to "Off," and turn off the power for zone 2. If "Control for HDMI" (page 103), "Pass Through" (page 103), or "Network Standby" (page 105) is set to "On," or the power for zone 2 is turned on, the lamp above ?/1 lights up in amber. Note The top of the receiver may become hot while the receiver is in standby mode. This condition occurs because current is flowing in the internal circuits of the receiver. This is not a malfunction. Performing initial setup operations (clearing all memorized settings) Before using the receiver for the first time, initialize the receiver by performing the following procedure. This procedure can also be used to revert back to the factory default settings. ?/1 TONE MODE 2CH/A.DIRECT continued 43US