Sony STR-DA3700ES Operating Instructions - Page 132
Tuner, The MULTI CHANNEL DECODING lamp
View all Sony STR-DA3700ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
Multi-channel sound cannot be output. • When "Control for HDMI" is set to "On," "Audio Out" may be automatically set to "AMP." In this case, set "Audio Out" to "AMP." The surround effect cannot be obtained. • Make sure the sound field function is on (press MOVIE/HD-D.C.S. or MUSIC). • "PLII (Movie/Music)," "PLIIx (Movie/ Music)," "PLIIz Height," and "Neo:6 (Cinema/Music)" do not work when the speaker pattern is set to 2/0 or 2/0.1. The MULTI CHANNEL DECODING lamp does not light up in blue. • Check that the playback equipment is connected on a digital jack and the input is selected properly on this receiver. • Check whether the input source of the software being played back corresponds to the multi-channel format. • Check whether the setup on the playback equipment is set to multi-channel sound. • Check to make sure the selected audio (digital) input jack is not assigned to other inputs in "Audio Input Assign" in the Connection Settings menu (page 82). Recording cannot be carried out. • Check that the equipment are connected correctly (page 37). • Select the source equipment (page 50). • Audio input signals via the HDMI IN jacks cannot be recorded. • Check the connection of the recording deck according to the audio signals you want to record. Analog input signals can be output only from the analog output jacks. Digital audio input signals can be output only from the OPTICAL OUT jack. • You may not make recordings using an SCMS-compliant recording deck. • Copyright protection to prevent recording is contained in the sources. In this case, you may not be able to record from the sources. A test tone is not output from the speakers. • The speaker cords may not be connected securely. Check to see if they are connected securely and cannot be disconnected by pulling on them slightly. • The speaker cords may have the shortcircuit problem. A test tone is output from a different speaker than the speaker displayed on the screen. • The speaker configuration set up is incorrect. Make sure that the speaker connections and the configuration match correctly. Tuner The FM reception is poor. • Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna (aerial) as shown on page 132. If you connect the receiver to an outdoor antenna (aerial), ground it against lightning. To prevent a gas explosion, do not connect the ground (earth) wire to a gas pipe. Outdoor FM antenna (aerial) Receiver Radio stations cannot be tuned in. • Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary. • Keep the satellite radio antenna, away from the speaker cords and the power cord to avoid picking up noise. 132US