Sony STR-DH710 Operating Instructions - Page 41
When a test tone is not output, from the speakers, a different speaker than - 7 1 channel receiver
UPC - 027242779976
View all Sony STR-DH710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Preparing the Receiver 4 Press V/v repeatedly to select "AUTO xxx*". The test tone is output from each speaker in sequence. * xxx represent a speaker channel. Note Depending on the speaker pattern settings, test tone may not be output from all speakers even though you select "AUTO xxx". 5 Adjust the speaker levels using the LEVEL menu so that the level of the test tone sounds the same from each speaker. For details, see LEVEL menu (page 76). Tips • To adjust the level of all speakers at the same time, press MASTER VOL +/- (RM-AAU073 only) or 2 +/- (RM-AAU075 only). You can also use MASTER VOLUME on the receiver. • The adjusted value are shown on the display during adjustment. 6 Repeat steps 1 to 4 to select "OFF". You can also press any input buttons. The test tone turns off. When a test tone is not output from the speakers • The speaker cords may not be connected securely. • The speaker cords may have the short-circuit problem. When a test tone is output from a different speaker than the speaker indicator showed in the display The speaker pattern to the connected speaker is not set up correctly. Make sure the speaker connection and the speaker pattern match. Note Test tone is not output from the headphones connected to the S-AIR surround amplifier. 41GB