Sony STR-DH710 Operating Instructions - Page 46
Using the controls on the, receiver, In case of poor FM stereo, reception
UPC - 027242779976
View all Sony STR-DH710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Tuning into a station automatically (Automatic Tuning) 1 Press TUNER repeatedly to select the FM or AM band. 2 Press TUNING + or TUNING -. Press TUNING + to scan from low to high; press TUNING - to scan from high to low. The receiver stops scanning whenever a station is received. Using the controls on the receiver 1 Turn INPUT SELECTOR to select the FM or AM band. 2 Press TUNING MODE repeatedly to select "AUTO". 3 Press TUNING + or TUNING -. In case of poor FM stereo reception If the FM stereo reception is poor and "ST" flashes on the display, select monaural audio so that the sound will be less distorted. 1 Press AMP MENU. 2 Press V/v repeatedly to select "TUNER", then press or b. 3 Press V/v repeatedly to select "FM MODE", then press or b. 4 Press V/v repeatedly to select "MONO", then press . To return to stereo mode, repeat steps 1 to 4 and select "STEREO" in step 4. Tuning into a station directly (Direct Tuning) You can enter the frequency of a station directly by using the numeric buttons. 1 Press TUNER repeatedly to select the FM or AM band. You can also use INPUT SELECTOR on the receiver. 2 Press D.TUNING. 3 Press and hold SHIFT, then press the numeric buttons to enter the frequency. Example 1: FM 102.50 MHz • Models of area code U2 and CA2: Select 1 b 0 b 2 b 5 • Models of area code AU1 and TW2: Select 1 b 0 b 2 b 5 b 0 Example 2: AM 1,350 kHz Select 1 b 3 b 5 b 0 4 Press and hold SHIFT, then press ENTER. You can also use MEMORY/ENTER on the receiver. Tip If you have tuned in an AM station, adjust the direction of the AM loop antenna (aerial) for optimum reception. If you cannot tune in a station Make sure you have entered the right frequency. If not, repeat steps 2 to 4. If you still cannot tune in a station, the frequency is not used in your area. 46GB