TASCAM DA-6400 DA-6400dp Owners Manual - Page 12
Note about the PARALLEL connector, Home Screen
![]() |
View all TASCAM DA-6400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
2 - Names and Functions of Parts Note about the PARALLEL connector The PARALLEL connector on the back of the unit allows external control of it. You can set the functions of the PARALLEL connector on the PARALLEL INPUT and PARALLEL OUTPUT pages. (See "PARALLEL connector settings" on page 38.) The factory default pin assignments are as follows. Pin No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 I/O Function (default value) O OUTPUT AUX1 (STOP TALLY) O OUTPUT AUX2 (REC TALLY) I INPUT AUX1 (TAKE SKIP +) I INPUT AUX2 (TAKE SKIP −) O OUTPUT AUX3 (ERROR TALLY) I INPUT AUX3 (FADER REC) I INPUT AUX4 (REW) GND O OUTPUT AUX4 (PLAY TALLY) O OUTPUT AUX5 (PAUSE TALLY) I INPUT AUX5 (F.FWD) I STOP I PLAY I INPUT AUX6 (PAUSE) +5V I: For command input and transport control Internal circuit with +5V pull-up Operates with low signal input of 50 msec or longer When INPUT AUX is set to FADER REC, low signal input starts recording and high signal input stops recording. When INPUT AUX is set to FADER START, low signal input starts playback and high signal input pauses playback. O: For command and tally output Internal circuit is open collector (10Ω output impedance) Outputs low command during operation 20V dielectric strength, 35mA maximum current +5V: 50mA maximum supplied current The following example is of a connection that controls recording and playback of this unit by level, using fader starts and stops and FADER REC commands. STOP Pin 8 : GND 1"3"--&- START Pin 6 : REC NOTE Setting multiple FADER REC and FADER START settings to INPUT AUX is not possible. Home Screen The following information is shown on the unit's display. 1 Transport status This icon shows the current transport status. Icon Meaning Playing back In playback standby Stopped Searching backward Searching forward Searching backward (high speed) Searching forward (high speed) Recording In record standby 2 Repeat status When repeat playback is off, the When repeat playback is on, the icon is unlit. icon is lit. 3 Solo status When the solo selection frame is white, the icon blinks. 4 Take number This shows the number of the take playing or being recorded. 5 Time counter This shows the elapsed recording/playback time of the take or the timecode time. 6 Time display mode This icon shows the current time display mode. Time display Meaning mode This shows the elapsed time from the beginning of the take. This shows the remaining time until the end of take. When recording, this shows the remaining time until the maximum file size is reached. This shows the total take elapsed time. During playback, this shows the total take remaining time. When recording, this shows the remaining available recording time. This shows the timecode time of the recording/ playback take. 12 TASCAM DA-6400/DA-6400dp
![](/manual_guide/products/tascam-da6400-da6400dp-owners-manual-d4cebcf/12.png)