TASCAM DA-6400 DA-6400dp Owners Manual - Page 13

2 - Names and Functions of Parts 7 Remaining media capacity This shows the remaining available recording time of the current media. No Media is shown when no SSD/HDD drive is loaded. UNFORMAT is shown if the loaded SSD/HDD drive has not been formatted. Rec Limit is shown if recording is not possible because the total number of folders, takes inside folders and other files would exceed the system limit. 8 Timecode status When the TC GENERATOR MODE screen is not set to TC SYNC REC. The TC indicator lights green when correct timecode is being input and recognized properly. The indicator does not light when input timecode recognition is abnormal. When the TC GENERATOR MODE screen is set to TC SYNC REC. The TC indicator lights red when correct timecode is being input and recognized properly. § The indicator flashes red when input timecode recognition is abnormal. 9 Audio synchronization status The name of the currently selected master clock is shown with the indicator. (See "Setting the master clock" on page 22.) When synchronized with the master clock, the indicator lights green. § When not synchronized with the master clock, the indicator blinks. 0 Time bar This shows the current playback position. What is shown depends on the time display mode. Time display mode Meaning Bar display Lengthens from the The current playback position is shown relative to the length of the take. left end toward the right end. Shortens from the left end toward the right end. The current playback Lengthens from the position is shown relative left end toward the to the length of all takes right end. in the folder. Shortens from the left (Vertical white lines show end toward the right divisions between takes.) end. The current playback Lengthens from the position is shown relative left end toward the to the length of the take. right end. NOTE During recording, a progress bar appears to extend from the left end to the right end about every 10 seconds. q Take name This shows the name of the currently loaded take. w Level meter display area This area shows the levels of the input and playback signals. When a level overloads, the bar meter becomes red and the channel number appears in a pop-up above it. e Solo selection frame The level meter for the channel currently output from the PHONES jack is shown with a white or gray frame. When the selection frame appears white, turn the MULTI JOG dial to select the channel output from the PHONES jack. Press the MULTI JOG dial while pressing and holding the SHIFT button to switch the headphone output solo selection frame to white/gray. When the PHONES MONITOR MODE screen setting is MONO, the solo selection frame will be for a mono channel. (See "Setting headphones monitoring mode" on page 20.) r Record function indicators These show whether recording is enabled or not for each channel. Recording enabled: Red Recording disabled: Gray t Marks An b icon is shown at each mark. y Mark name This shows the name of the mark at or immediately before the current time. u Level meter guide This level meter guide can be used to evaluate input and output levels. This line is shown at −18 dB. The position of the guide and the value (t 18 g) shown depend on the value set on the REFERENCE LEVEL screen. (See "Setting the reference level" on page 23.) i Input monitoring indicator area These show whether input monitoring is enabled or not for each channel. Input monitoring on: Blue Input monitoring off: Unlit NOTE When the sampling frequency is 88.2/96 kHz, the following data in the area for channels 33-64 is not shown. ii Level meters ii Record function indicators ii Input monitoring indicators Furthermore, the solo selection frame cannot be moved to channels 33-64. TASCAM DA-6400/DA-6400dp 13