TP-Link T2500G-10MPS T2500G-10MPSUN V1 Configuration Guide - Page 103

Managing Physical Interfaces Basic Parameters Configurations 2 Basic Parameters Configurations 2.1 Using the GUI Choose the menu Switching > Port > Port Config to load the following page. Figure 2-1 Configuring Basic Parameters Follow these steps to set basic parameters for ports: 1) Set the jumbo frame value and click Apply. The default MTU (Maximum Transmission Unit) size for frames received and sent on all ports is 1518 bytes. A higher value means allowing the port to send jumbo frames. The valid values are from 1518 to 9216 bytes. 2) Select and configure your desired ports or LAGs. Then click Apply. UNIT:1/LAGS Click 1 to configure physical ports. Click LAGS to configure LAGs. Type Displays the port type. Copper indicates an Ethernet port, and SFP or SFP+ indicates a fiber port. Description Give a port description for identification. Status With this option enabled, the port forwards packets normally. Otherwise, the port discards all the received packets. By default, it is enabled. Speed Select the appropriate speed mode for the port. When Auto is selected, the port autonegotiates speed mode with the connected device. The default setting is Auto. This value is recommended if both ends of the line support autonegotiation. Configuration Guide 76