TP-Link T2500G-10MPS T2500G-10MPSUN V1 Configuration Guide - Page 91

Managing System Access Security Configurations Switch(config)#user access-control ip-based 192.168.0.100 255.255.255.0 snmp telnet http https Switch(config)#show user configuration User authentication mode: IP based Index IP Address Access Interface 1 192.168.0.0/24 SNMP Telnet HTTP HTTPS Switch(config)#end Switch#copy running-config startup-config 5.2.2 Configuring the HTTP Function Follow these steps to configure the HTTP function: Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 configure Enter global configuration mode. ip http server Enable the HTTP function. By default, it is enabled. ip http session timeout minutes Specify the Session Timeout time. The system will log out automatically if users do nothing within the Session Timeout time. minutes: Specify the timeout time, which ranges from 5 to 30 minutes. The default value is 10. ip http max-users admin-num operator-num poweruser-num user-num Specify the maximum number of users that are allowed to connect to the HTTP server. The total number of users should be no more than 16. admin-num: Enter the maximum number of users whose access level is Admin. The valid values are from 1 to 16. operator-num: Enter the maximum number of users whose access level is Operator. The valid values are from 0 to 15. poweruser-num: Enter the maximum number of users whose access level is Power User. The valid values are from 0 to 15. user-num: Enter the maximum number of users whose access level is User. The valid values are from 0 to 15. show ip http configuration Verify the configuration information of the HTTP server, including status, session timeout, access-control, max-user number and the idle-timeout, etc. end Return to privileged EXEC mode. Configuration Guide 64