TP-Link T2500G-10MPS T2500G-10MPSUN V1 Configuration Guide - Page 768

Configuring SNMP & RMON Notification Configurations 3 Notification Configurations With Notification enabled, the switch can send notifications to the NMS about important events relating to the device's operation. This facilitates the monitoring and management of the NMS. Configuration Guidelines  To guarantee the communication between the switch and the NMS, ensure the switch and the NMS are able to reach one another.  Functions of the SNMP Trap can be configured only with CLI. If needed, please refer to Enabling the SNMP Standard Trap, Enabling the SNMP PoE Trap, (Optional) Enabling the SNMP Extend Trap, (Optional) Enabling the DDM Trap, and (Optional) Enabling the Linkstatus Trap. 3.1 Using the GUI Choose the menu SNMP > Notification > Notification Config to load the following page. Figure 3-1 Notification Config Follow these steps to configure notification: 1) Specify the IP address of the host, the UDP port that sends notifications, and choose the IP mode according to the network environment. IP Address If you set the IP Mode to IPv4, specify an IPv4 address for the host. If you set the IP Mode to IPv6, specify an IPv6 address for the host.. UDP Port Specify a UDP port on the host to send notifications. The default is port 162. For communication security, we recommend that you change the port number under the condition that communications on other UDP ports are not affected. Configuration Guide 741