TP-Link T2500G-10MPS T2500G-10MPSUN V1 Configuration Guide - Page 140

Configuring LAG LAG Configuration Step 5 Step 6 end Return to privileged EXEC mode. copy running-config startup-config Save the settings in the configuration file. The following example shows how to add ports1/0/5-8 to LAG 2 and set the mode as static LAG: Switch#configure Switch(config)#interface range gigabitEthernet 1/0/5-8 Switch(config-if-range)#channel-group 2 mode on Switch(config-if-range)#show etherchannel 2 summary Flags: D - down P - bundled in port-channel U - in use I - stand-alone H - hot-standby(LACP only) s - suspended R - layer3 S - layer2 f - failed to allocate aggregator u - unsuitable for bundling w - waiting to be aggregated d - default port Group Port-channel Protocol Ports ------- 2 Po2(S) - Gi1/0/5(D) Gi1/0/6(D) Gi1/0/7(D) Gi1/0/8(D) Switch(config-if-range)#end Switch#copy running-config startup-config  Configuring LACP Follow these steps to configure LACP: Step 1 configure Enter global configuration mode. Step 2 lacp system-priority pri Specify the system priority for the switch. To keep active ports consistent at both ends, you can set the priority of one device to be higher than that of the other device. The device with higher priority will determine its active ports, and the other device can select its active ports according to the selection result of the device with higher priority. If the two ends have the same system priority value, the end with a smaller MAC address has the higher priority. pri: System priority. The valid values are from 0 to 65535, and the default value is 32768. A smaller value means a higher device priority. Configuration Guide 113