TP-Link T2500G-10MPS T2500G-10MPSUN V1 Configuration Guide - Page 635

Configuring Network Security 802.1X Configuration Step 6 Step 7 Step 8 Step 9 dot1x port-control { auto | authorized-force | unauthorized-force } Configure the control mode for the port. By default, it is auto. auto: If this option is selected, the port can access the network only when it is authenticated. authorized-force: If this option is selected, the port can access the network without authentication. unauthorized-force: If this option is selected, the port can never be authenticated. show dot1x interface [fastEthernet port |gigabitEthernet port | ten-gigabitEthernet port] (Optional) Verify the configurations of 802.1X authentication on the port. port: Enter the ID of the port to be configured. If no specific port is entered, the switch will show configurations of all ports. end Return to privileged EXEC mode. copy running-config startup-config Save the settings in the configuration file. The following example shows how to enable 802.1X authentication on port 1/0/2, configure the control type as port-based, and configure the control mode as auto: Switch#configure Switch(config)#interface gigabitEthernet 1/0/2 Switch(config-if)#dot1x Switch(config-if)#dot1x port-method port-based Switch(config-if)#dot1x port-control auto Switch(config-if)#show dot1x interface gigabitEthernet 1/0/2 Port State GuestVLAN PortControl PortMethod Authorized LAG ---- ----- --------- -------- -------- Gi1/0/2 enabled disabled auto port-based unauthorized N/A Switch(config-if)#end Switch#copy running-config startup-config Configuration Guide 608