TP-Link T2500G-10MPS T2500G-10MPSUN V1 Configuration Guide - Page 487

Configuring QoS Bandwidth Control Configuration Step 2 interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range gigabitEthernet port-list} Enter interface configuration mode. Step 3 storm-control {broadcast | multicast | unicast} {kbps | ratio} rate broadcast | multicast | unicast: Enable broadcast packets rate limit, multicast packets rate limit or unknown unicast frames rate limit on the port. kbps: Configure the storm control mode as kbps. In this mode, the upper rate limit is specified in kilo-bits per second. ratio: Configure the storm control mode as ratio. In this mode, the upper rate limit is specified as a percentage of the bandwidth. rate: Specify the upper rate limit for receiving broadcast packets, multicast packets and unknown unicast frames on the port. The packet traffic exceeding the rate will be discarded. For kbps, the valid rate values are from 1 to 1000000 kbps; for ratio, the valid rate values are from 1 to 100 percent. Step 4 show storm-control {interface [fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range gigabitEthernet port-list]} Verify the storm control configurations of the port. If no port is specified, it displays the storm control configuration for all ports. Step 5 end Return to privileged EXEC mode. Step 6 copy running-config startup-config Save the settings in the configuration file. The following example shows how to configure the upper rate limit of broadcast packets as 10240 kbps on port 1/0/5: Switch#configure Switch(config)#interface gigabitEthernet 1/0/5 Switch(config-if)#no storm-control pps Switch(config-if)#storm-control broadcast kbps 10240 Switch(config-if)#show storm-control interface gigabitEthernet 1/0/5 Port BcRate Mcate UlRate LAG Gi1/0/5 kbps 10240 kbps 0 kbps 0 N/A Switch(config-if)#end Switch#copy running-config startup-config Configuration Guide 460