Xerox C2424 Service Manual - Page 102
XX.4x Error - I/O Circuit Board Fault, 0XX.6x Errors - I/O Board Program Faults
UPC - 095205676532
View all Xerox C2424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
2,0XX.4x Error - I/O Circuit Board Fault 2,001.47: The print engine cannot detect the presence of the I/O circuit board. Troubleshooting Procedure Step Questions or Actions 1 1. Are all wiring connections to and from the I/O Board properly seated? 2 1. Reseat the connections. 2. Power on the sytem. 3. Did the error reoccur? 3 1. Test the wiring from the I/O board J840 to the power control board J800. Yes Go to Step 3. No Go to Step 2. Go to Step 3. Complete. Replace the I/O Board. 2,0XX.6x Errors - I/O Board Program Faults 2,001.69: The electronics module failed to initialize. 2,002.61: This fault code indicates a problem with the system program. The engine firmware was unable to initialize the queues used for inter-task communication. 2,003.62: This fault code indicates a problem with the system program. The engine firmware was unable to start the service diagnostics tasks. 2,004.63: Failure to start the print engine in suspend mode. 2,005.64: This fault code indicates a problem with the system program. ROM could not be opened for reading (idiags). 2,006.65: This fault code indicates a problem with the system program. ROM could not be loaded (idiags). 2,007.66: This fault code indicates a problem with the system program (idiags) entry point cannot be found. a. Reset NVRAM and retest. b. Ensure ground integrity for the system (see "Ensuring Ground Integrity" on page 4-73). c. Replace the EEPROM chip. d. Reboot the system. 3,0XX.6x - IPC Program Faults There is a communication problem between the engine and PostScript regions. a. Reset NVRAM, and then retest. b. Replace the EEPROM chip. 3-10 WorkCentre C2424 Service Manual