Xerox C2424 Service Manual - Page 347
Assembly. Videos are located on the WorkCentre C2424 Product, PL 2.3
UPC - 095205676532
View all Xerox C2424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 347 highlights
Drum Assembly (PL 2.3) Videos are available with instructions for replacing the Drum Assembly. Videos are located on the WorkCentre C2424 Product training CD-ROM. 1. Remove the DADF, scanner assembly, output tray assembly, left and right side covers and the ink loader (see page 4 thru page 13). 2. Ensure that the printhead is in park position (tilted back) and the wiper assembly is in the home position (all the way down). 3. Remove the transfix load module (page 8-30). 4. Remove the media gearbox from the left side of the printer (page 8-52). 5. Remove the Y-axis belt. Relieve tension on the belt by pulling the end of the spring arm toward the front of the printer using your fingers. (See the figure on page 14.), then slide the belt off the pulley. 6. Remove 3 screws from the drum fan, note the location of the ground clip, and allow the fan to hang free. 7. Unplug the drum heater cable from the relay board and free the cable from the retaining hook. 8. Unplug the drum encoder cable connector from the power control left cable and free the cable from the retaining hook. 9. Unplug the drum thermistor cable connector from the I/O Board (J870). 10. Remove the EMA assembly (page 8-42). Note Note the wire routing for the sensor on the drum. Caution The drum thermal sensor cable is routed through the MEP. Use care during removal to avoid damaging the sensor. Service Parts Disassembly 8-37