Xerox C2424 Service Manual - Page 354

Replacement Note: After installing the MEP, perform the Wiper Alignment (page 6-2). The printer may report error code 7,009.4x if the wiper assembly is misaligned. Paper Guides Inner Simplex (PL 3.1) 1. Open the printer front door to access the guide. 2. Using a small flatblade screwdriver, pry inward on one retainer to remove it from the mounting post then remove the other retainer. 3. Slide the guide down and forward to remove. Replacement Note: Note The fingers on the Inner Simplex Guide, go over the segmented roller. First snap the left retainer into place, then the right. Lower Inner Duplex (PL 3.2) 1. Open the front door. 2. Pull out on the tabs at the bottom of the guide and let the guide swing free. 3. Pry inward (toward the center of the printer) on the right upper retainer until it is free of the mounting boss and remove the guide. Lower Exit-Guide Assembly with Strip Flag (PL 3.13) 1. Open the exit cover. 2. Lift upward on the center of the guide, then flex the left retainer inward to remove it. 3. Remove the right retainer and remove the guide. 8-44 WorkCentre C2424 Service Manual