Yamaha CLP-611 Owner's Manual - Page 34

5.2 S.Balance (Voice volume balance) Values: 0,...,20 [10 = equal balance] [Right voice gets louder as value increases.] Default: Varies according to voice combination Sets the relative volumes for the two voices. 5.3 VcR.Octave (Octave shift for right zone) 5.4 VcL.Octave (Octave shift for left zone) Values: -1, 0, +1 Default: Varies according to voice combination These subfunctions allow you to shift each voice up or down an octave. Set the values in accordance with the range of the music you are playing. 5.5 VcR.EffDpt (Effect depth for right zone) 5.6 VcL.EffDpt (Effect depth for left zone) Values: 0,...,20 Default: Varies according to voice combination These subfunctions allow you to set separate effect depths for each zone. Setting is not available if the effect is OFF. Note that you cannot change a voice's effect selection while working in FUNCTION mode; you must first exit the mode. 5.7 Sus.Pedal (Effective range of damper pedal) Values: L, L+R, R Default: L+R Selects whether the damper pedal operates on both zones (L+R), on the left zone only (L), or on the right zone only (R). 5.8 ResetOK? (Return to factory defaults.) Press [+/YES] to reset all of the SPLIT-mode subfunction settings to their factory-default values. (Factory defaults are different for each voice combination.) NOTE As a shortcut, you can switch directly into FUNCTION mode's F5.SplitFunc. area by holding down [SPLIT] and pressing the [FUNCTION] button. Once you have changed the settings, press [FUNCTION] again to return to normal mode. F6.OrganEdit (ORGAN COMBINATION settings) The CLP-811/611 offers you eight different editable organ types. You use the OrganEdit function to edit these types, and to select the type to be played. • You can use the Backup function (F15 on the CLP-811, F14 on the CLP-611) to select whether editing results are retained after power goes off. See page 36. You edit an organ voice by adjusting its various stops - each represented as a separate bar that appears on the display - and by setting a variety of other edit parameters. Specifically, you can edit the following items for each of the eight organ types. • Volume levels for each of eight continuous tones • Response time for continuous tones • Volume levels for each of three decay (attack) tones • Attack length for the three decay tones • Attack mode (EACH or FIRST) • Rotary speaker effect (depth and speed) As an example, you can build a very realistic percussive organ sound by applying appropriate decay volumes and attack length. Or you might create a pipe-organ sound by combining slow response with a weak attack. 1 To access this function: first select the ORGAN COMBINATION voice, then enter FUNCTION mode and go to main function F6. 1 2 ROOM NORMAL MEDIUM BRILLIANCE REVERB EFFECT TOUCH TEMPO 2 Next, press [+/YES] to enter the subfunction group. Then use [t], [s] to move among the different subfunctions, and [-/NO], [-/YES] to set the values. (But see additional information below regarding operation of the VoiceEdit subfunction.) NOTE If the ORGAN COMBINATION voice is not yet selected when you move to the main F6 screen... The top right of the screen will display a triple dash (---), and you will not be able to enter the subfunction group. To enable entry, you must first select the ORGAN COMBINATION voice. (You can do this without leaving FUNCTION mode.) 30 CLP-811/611 Configuration Functions (FUNCTION mode)